How to Handle Asbestos Containing Debris
|Air Pollution Control Program fact sheet||
|Division of Environmental Quality Director: Leanne Tippett Mosby||
Asbestos is a naturally occurring mineral fiber. Due to its unique properties, it was used in a number of different building materials into the 1970s and may still be found in some products currently being manufactured. It is estimated that manufacturers used asbestos in more than 3,000 different commercial applications.
Examples of these materials include:
- Cementitious siding and wallboard (transite)
- Asphalt and vinyl floor tile and sheet flooring
- Flooring mastics
- Textured paints
- Acoustical plaster
- Ceiling tiles and panels
- Fireproofing materials
- Heater curtains
- Blown-in insulation
- Boiler insulation
- HVAC duct insulation
- Pipe insulation
- Roofing shingles and felts
- Joint compound spackling compounds
- Brake pads
Potential Health Effects from Asbestos Exposure
There is no known safe level of asbestos exposure. Asbestos fibers are very small and can migrate through the body’s natural defense system into the lungs, where they can cause damage to the respiratory system.
There are three major health risks associated with asbestos exposure:
- Asbestosis, which is a scarring of the lungs.
- Mesothelioma, which is a cancer of the lining of the lungs and the abdominal cavity.
- Lung cancer.
Categories of Asbestos Containing Materials
There are three categories of asbestos containing materials:
- Friable asbestos containing materials.
- Category I non-friable asbestos containing materials.
- Category II non-friable asbestos containing materials.
Friable asbestos containing material is any material containing greater than one percent
asbestos that, when dry, can be crumbled, pulverized or reduced to powder by hand pressure.
These materials will more readily produce asbestos fibers if disturbed or removed. Examples of
friable materials include sprayed or troweled materials such as acoustical ceiling spray, boiler
insulation, paper pipe insulation and drop-in ceiling tile.
Category I non-friable asbestos containing material is asbestos containing packings, gaskets, resilient floor coverings and asphalt roofing products containing more than one percent asbestos. The asbestos in Category I materials is more tightly bound in the matrix of the material. These materials are less likely to generate asbestos fibers if they are in good condition and are not subject to sanding, grinding, cutting or abrading. Also, any vapor barrier on resilient floor coverings such as sheet vinyl or tile is considered friable asbestos if the flooring is removed in a manner that causes the vapor barrier to delaminate or separate from the covering.
Category II non-friable asbestos containing material is any non-friable material, other than category I materials, that contain more than one percent asbestos. The asbestos tends to be more tightly bound in the matrix of these materials. If not removed prior to demolition or renovation these materials have a higher probability of becoming crumbled, pulverized or reduced to powder, which may make it subject to regulation. If removed properly, these materials are not regulated by the department. Examples of category II materials include transite wall or roof shingles, wall board or cement pipe.
Identifying Asbestos Containing Materials
The department requires institutional, commercial, public, industrial or residential structures, excluding certain residential structures to be inspected for the presence of asbestos prior to being renovated or demolished. This inspection must be performed by a Missouri-certified asbestos inspector.
In the case of a natural disaster where a building has been damaged, and may be structurally unstable, alternate inspection and notification requirements may apply. In this event, contact the Air Pollution Control Program or your Regional Office to discuss requirements. The building and debris should be kept wet to minimize the potential for any emissions of asbestos to occur. After the danger of the unsafe structure has been eliminated, an inspection of the resulting debris may be required.
For residential structures that contain four or fewer dwelling units there is an exemption from this inspection requirement, unless the demolition or renovation project involves multiple buildings under the control of the same owner or operator, or the structure is to be burned as part of a fire training exercise. However, this does not mean that asbestos found in these exempt structures is not dangerous if disturbed. If you suspect damaged material might contain asbestos, the department recommends you not further disturb the material until it can be determined if it is asbestos containing or not. For the purpose of identifying asbestos containing materials, the department recommends you obtain the services of a Missouri certified asbestos inspector to positively identify any suspect materials or that you assume the material contains asbestos. It is recommended any debris be kept wet until an adequate determination of the presence of asbestos can be made.
Requirements for Removal of Regulated Asbestos
If the demolition or renovation to an institutional, commercial, public, industrial or residential structure (excluding exempt residential structures as described in the preceding section) will involve greater than 160 square feet, 260 linear feet, or 35 cubic feet of regulated asbestos containing materials, then the removal of the asbestos is regulated by the department. For projects that meet these thresholds, a Missouri registered contractor and Missouri certified asbestos workers must be used to perform the abatement of the material. If buildings have been demolished or destroyed by a natural disaster prior to removing the asbestos, then any debris subsequently contaminated by asbestos must also be handled as asbestos containing waste. The department's Air Pollution Control Program should be contacted for guidance.
The department must be notified about all abatement projects involving greater than a threshold amount of asbestos and for all demolition projects regardless of whether asbestos is present or not. Typical notification requirements would require a 10 working day notification. However, in the case of buildings that have been damaged as a result of a natural disaster, the department will waive this 10-day notice requirement. However, notice should be sent to the department within 24 hours of either starting a regulated abatement or demolition project.
There is no requirement to use a Missouri registered contractor for asbestos removal for unregulated demolition or renovation projects that involve less than the threshold levels listed above for friable asbestos containing materials, non-friable asbestos containing materials or asbestos containing materials from exempt residential structures. However, using trained professionals for the removal of asbestos containing materials is recommended.
Other agencies, such as the Occupational Safety and Health Administration (OSHA), also have requirements for the safe handling of asbestos containing materials. For OSHA related requirements contact OSHA in St. Louis at 800-392-7743 or in Kansas City at 800-892-2674.
Precautions to Take to Minimize Asbestos Exposure
If damaged materials are suspected of containing asbestos, it is recommended the materials not be disturbed until it can be properly identified. If you elect to remove or disturb asbestos containing materials from unregulated demolition or renovation projects, proper precautions should be taken to minimize any potential exposure.
- Seal off work areas where asbestos containing materials may be present, and take care not to track asbestos dust into other areas.
- Always wear an approved respirator and disposable protective clothing. Decontaminate yourself before going into uncontaminated areas.
- When working with asbestos containing material, keep the material wet to keep emission of asbestos fibers to a minimum.
- Avoid breaking the material into smaller pieces. While smaller pieces may be easier to handle, this will increase the possibility of asbestos emissions.
- Place any material you remove into appropriate leak tight disposal packaging or containers while the material is wet.
- Transport the asbestos waste material to an approved disposal facility in an enclosed dumpster or truck lined with plastic sheeting.
Waste Disposal Requirements for Asbestos Contaminated Debris
All asbestos containing waste, whether from a regulated or unregulated demolition or renovation project is a waste material and must be disposed of at a permitted solid waste disposal facility that will accept the material. Asbestos containing materials should never be burned for disposal, as this will generate the emissions of asbestos fibers into the air, and is in violation of the department’s open burning requirements. For regulated projects, the department has stringent requirements for the packaging and labeling of asbestos containing waste materials. While the department has no requirements for packaging and labeling of asbestos containing waste materials from unregulated projects, you should still make arrangement with the disposal facility that you intend to use to determine what packaging and labeling requirements they may have for acceptance of the materials at their facility.
Locating Trained Asbestos Professionals
The Missouri Department of Natural Resources’ Air Pollution Control Program maintains lists of all Missouri-certified asbestos inspectors and all Missouri registered asbestos abatement contractors. These lists are available on the department’s website at http://dnr.mo.gov/env/apcp/asbestos/ or by contacting the Air Pollution Control Program at 573-751-4817.
Asbestos Contact Information
For more information on the department’s asbestos requirements, you may contact the department’s Air Pollution Control Program or one of the department’s other offices:
In Missouri, there are two local agencies that have an agreement with the department to enforce Missouri’s asbestos requirements as well as local ordinances. These local agencies are:
|Kansas City||Kansas City Health Department
Air Quality Program
|St. Louis County||St. Louis County Health Department||314-615-8924|
Two additional local agencies do not enforce Missouri’s asbestos requirements but may have local ordinances concerning asbestos which they enforce:
|St. Louis (city)||St. Louis Division of Air Pollution Control
Air Quality Program
|Springfield||Springfield-Greene County Health Department of Environmental Services||417-864-1412|
Prior to performing a project in one of these jurisdictions, you should contact the appropriate agency to determine if any additional requirements apply.
Missouri Department of Natural Resources
Air Pollution Control Program
P.O. Box 176
Jefferson City, MO 65102
Other Department Offices
Kansas City Regional Office
500 NE Colbern Road
Lee's Summit, MO 64086-4710
Northeast Regional Office
1709 Prospect Dr.
Macon, MO 63552-2602
St. Louis Regional Office
7545 S. Lindbergh, Suite 210
St. Louis, MO 63125
Southeast Regional Office
2155 N. Westwood Blvd.
Poplar Bluff, MO 63901
Southwest Regional Office
2040 W. Woodland
Springfield, MO 65807-5912
Additional Asbestos Related Guidance Documents
For more specific information about the department’s requirements in regard to asbestos, reference the additional guidance documents listed below or contact the department or appropriate local agency at the contact information found in this fact sheet.
These documents are available for free download from the department’s website at www.dnr.mo.gov/pubs/index.html.
- Asbestos Requirements for Demolition and Renovation Projects, Fact Sheet--PUB2157
- Asbestos: What is it and why is it a concern?, Fact Sheet--PUB2077
- Management of Nonfriable Asbestos Containing Materials, Fact Sheet--PUB2156
- Requirements for Fire Training Exercises Involving Structures, Fact Sheet--PUB2029